How to use compass

Conduits developer
2017-09-12 04:21

How to switch compass mode in WEAR (Round face):

By tapping the lower left side of the face, the time display character part switches to compass angle display.
By tapping the time display character part in this state, the full screen switches to the compass screen.
From the compass screen, tap the top center of the screen to return to the original watch face.

How to switch compass mode in WEAR (Square face):

Tap [COMP] displayed in the face to switch to compass screen.
From the compass screen, tap the time display part at the top of the screen to return to the original watch face.

Settings in advance :

  1. (If necessary) Select the destination with the SIMTREK Configuration software on the smartphone.
    In the SIMTREK Configuration software on the smartphone, press the [Select destination] button from the [Settings] - [Step count and distance] screen.
    As the map is displayed, press and hold the point you want as the destination.
    It will be completed if a message stating that the destination was registered is displayed.
  2. When this destination information is notified to Wear by communication, the target arrow and the distance will be displayed on the compass screen of SIMTREK watch face.

About the operation of compass

The compass calculates the angle using the values read from the two sensors (Accelerometer, Magnetic Field).
Unfortunately we can not use compass in Wear where these two sensors are not equiped.

Also, if your wear is SONY SWR50, it seems there are times when it can not be read even if a sensor is equiped.

There is an example that it cured by updating the firmware of SWR50 to the latest,
Even so, there seems to be an example that it only cures for a short time.
(So we do not recommend updating the firmware ...)

Average rating: 0 (0 Votes)

You can comment this FAQ